基于分层组合法推导钢骨—钢管高强混凝土抗弯承载力
详细信息 本馆镜像全文    |  推荐本文 | | 获取馆网全文
摘要
为了研究钢骨-钢管高强混凝土的抗弯性能,采用截面分层组合法汇编非线性分析程序,分析不同钢管强度、钢骨强度、钢管厚度、钢骨截面惯性矩和混凝土强度等级对组合构件的抗弯力学性能的影响,并对计算结果回归分析,得出实用的抗弯承载力计算公式。研究结果表明:以上因素对其抗弯力学性能有不同程度的影响,但是钢管壁厚的变化对组合构件的抗弯力学性能影响幅度最大;抗弯承载力计算公式与试验结果整体吻合良好。研究结论对合理利用材料来提高组合构件的抗弯承载力,以及对组合构件的抗弯承载力计算是有实际工程意义的。
In order to study the bending performance of steel tubular steel-reinforced concrete(STSRHC),nonlinear analysis programs were assembled by sectional layered method.And then the impact of different yield stress of steel tube,different inserted steel bar strength,different thickness of steel tube,different steel bar moment of inertia and different concrete strength on the bending behavior of the composite members were analyzed using these programs.Finally apractical formula for calculating flexural bearing capacity was obtained through regression analysis of the results.The results indicate that the above mentioned parameters have different influences on the bending mechanical properties,with the thickness of steel tube being the major one.In addition,the calculated results of the formula agree well with those of the experimental ones.The conclusions of this study have practical engineering significance on improving the bending performance of the composite members through rational utilization of materials as well as calculating the capacity.
引文
[1]赵大洲.钢骨-钢管高强度混凝土组合柱力学性能研究[D].大连:大连理工大学,2003.
    [2]关萍,王清湘,赵大洲.钢骨-钢管高强度混凝土受弯组合柱的试验研究[J].地震工程与工程震动,2003,23(2),57-60.
    [3]王清湘,赵大洲,关萍.钢管-钢骨高强混凝土轴压组合柱受力性能的试验研究[J].建筑结构学报,2003,24(6):44-49.
    [4]刘晓,王连广,王兵.钢管钢骨高强混凝土抗弯构件试验研究[J].哈尔滨工业大学学报,2010,42(10):1651-1655.
    [5]Guan P,Chen L X.Influence of load condition on flexural properties and shear properties of steel tubular columns filled with steel-reinforced concrete[J].Applied Mechanics and Materials,Trans Tech Publications,Switzerland,2014,638-640:127-131.
    [6]丁发兴,余志武.圆钢管自密实混凝土纯弯力学性能[J].交通运输工程学报,2006,6(1):63-68.
    [7]Roeder C W,Leham D E,Bishop E.Strength and stiffness of circular concrete-filled tubes[J].Journal of Structural Engineering,2010,(12):1545-1553.
    [8]张岚.方钢管混凝土压弯构件截面非线性分析[J].工业建筑,2013,43(5):132-136.
    [9]韩林海,陶忠.现代组合结构和混合结构-试验、理论和方法[M].北京:科学出版社,2009.
    [10]赵同峰,王连广.方钢管-钢骨高强混凝土抗弯承载力分析[J].工业建筑,2008:38(3):27-30.
    [11]赵艳艳,吴乃森,王元生,等.矩形钢管混凝土梁的抗弯承载力仿真分析[J].计算机仿真,2011,28(9),382-385.
    [12]卢辉,韩林海.圆钢管混凝土抗弯刚度计算方法探讨[J].工业建筑,2004,34(1):1-5.
    [13]王刚,钱稼茹,林立岩.钢管混凝土叠合构件受弯性能分析[J].工业建筑,2006,3(2):68-71.
    [14]韩林海.钢管混凝土结构[M].北京:科学出版社,2000.
    [15]钟善桐.钢管混凝土结构(第三版)[M].北京:清华大学出版社,2003.

版权所有:© 2023 中国地质图书馆 中国地质调查局地学文献中心