钢筋混凝土框架结构抗震加固方法应用研究
详细信息 本馆镜像全文    |  推荐本文 | | 获取馆网全文
摘要
基于大量钢筋混凝土框架结构建筑物接近设计使用年限,或者部分建筑在遭受地震后出现不同程度的损坏、或者国内部分地区抗震设防要求提高等原因,许多建筑物需要按照现行规范进行抗震加固。本文以某钢筋混凝土框架结构公寓楼抗震加固工程为例,分别应用增设剪力墙、增设钢支撑、扩大柱截面三种方法进行加固设计,然后采用ANSYS软件对加固后结构的弹性位移角、结构构件内力、结构弹塑性位移角进行对比分析,同时结合实际施工要求进一步分析了每种方法的可行性,归纳出三种方法的优劣,为该加固工程选择合适的加固方法提供依据。通过本文的研究,期望为类似工程的抗震加固提供一定的参考。
Because a large number of buildings is close to design working life,some buildings appear varying degrees of damage after earthquake,at the same time the domestic parts requirements for seismic resistance have been increased,so there are a large number of buildings need to be reinforced in accordance with the current specification seismic strengthening code. Taking a seismic reinforcement project of a reinforced concrete frame as an example,three strengthening methods is applied to the structure,such as adding steel support,arranging the steel reinforcement,enlarging section method,then the software ANSYS is used to analyze the elastic displacement angle,internal force and elastic-plastic displacement angle of the structure,at the same time have a further analysis combined with the actual construction requirements,summ up the pros and cons of three kinds of strengthening methods. It could provide a basis to choose the appropriate reinforcement method for the reinforcement project and a powerful reference for future similar projects.
引文
[1]李永录.地震灾后建筑鉴定与加固技术指南[M].北京:中国建筑工业出版社,2008:7~10Li Yong-lu.The Technology Guide of Building Identification and Reinforcement after Earthquake[M].Beijing:China Architecture&Building Press,2008:7~10(in Chinese)
    [2]GB50292-1999,民用建筑可靠性鉴定标准[S]GB50292-1999,Civil Construction Reliability Evaluation Standard[S](in Chinese)
    [3]宁风,包联进,徐小华.结构抗震新技术在世博永久建筑中的应用[J].建筑结构,2011,41(3):36~40Ning Feng,Bao Lian-jin,Xu Xiao-hua.The Application of Structural Seismic New Technology in the Expo Permanent Structures[J].Building Sturcture,2011,41(3):36~40(in Chinese)
    [4]GB50011-2010,建筑抗震设计规范[S]GB50011-2010,Code for Seismic Design of Building[S](in Chinese)
    [5]王社良.抗震结构设计[M].武汉:武汉理工大学出版社,2007Wang She-liang.Structure Seismic Design[M].Wuhan University of Technology Press,2007(in Chinese)
    [6]徐培福,孙建超,黄世敏.中国国家博物馆改扩建工程结构总体设计[J].建筑结构,2011,(6):34~37Xu Pei-fu,Sun Jian-chao,Huang Shi-min.The Overall Design Projects of the National Museum of China Structure[J].Building Sturcture,2011,(6):34~37(in Chinese)
    [7]胡凯,储隽,谢宇峰,等.某单跨框架结构抗震加固设计与分析[J].建筑结构,2010,40(S2):7~9Hu Kai,Chu Xie,Xie Yu-feng,et al.Seismic Strengthening Design and Analysis of a Single Span Frame Structure[J].Building Sturcture,2010,40(S2):7~9(in Chinese)
    [8]张俊斌.既有中小学校舍加固方法的研究[D].昆明理工大学,2012:11Zhang Jun-bin.Studies of Reinforcement Method for Both Primary and Secondary School Buildings[D].Kunming:Kunming University of Science and Technology,2012:11(in Chinese)

版权所有:© 2023 中国地质图书馆 中国地质调查局地学文献中心