基于片上可编程系统的可控震源扫描信号研究与设计
详细信息 本馆镜像全文    |  推荐本文 | | 获取馆网全文
摘要
在可控震源地震勘探中,不同的地质条件需要设置不同的激发参数,如何选择合适的激发参数并实现相应的扫描信号是必须关注的问题。在分析可控震源的线性扫描的起止频率、扫描长度、扫描斜坡函数和长度参数及伪随机扫描的阶次与载波频率对扫描信号质量的影响后,通过片上可编程系统设计了VSG硬件IP核与信号发生器系统,依据分析的信号选择原则实现了对应扫描信号的产生,达到扫描信号的技术指标。
Vibrosesis is of increasingly important value in geological exploration.During the field work,different geological conditions need different parameters,the choice of suitable excitation parameters and the realization of the appropriate sweep signal become important problems.Main numbers of controlled seismic source,start-end frequency,scanning length,scanning slopes and its length in linear sweep signal,pseudo code order and carrier frequency in pseudo sweep signal were analyzed and discussed in this paper,and the influence of these parameters on quality of the sweep signal was studied in detail.The design of IP core of VSG hardware and the signaling system based on SOPC can meet the technical indices of the sweep signal.
引文
[1]林君.电磁驱动可控震源地震勘探原理及应用[M].北京:科学出版社,2004.
    [2]沈媛媛,郑恭明,刘益成等.可控震源伪随机扫描信号的研究[J].物探与化探,201034(3):2569-2574.
    [3]薛海飞,董守华,陶文朋.可控震源地震勘探中的参数选择[J].物探与化探,201034(2):185-190.
    [4]肖国镇,粱传甲,王玉民.伪随机序列及其应用[M].北京:国防工业出版社,1985.
    [5]王晓迪,张景秀.SOPC系统设计与实践[M].北京:北京航天航空大学出版社,2008.
    [6]李兰英.Nios嵌入式软核SOPC设计原理及应用[M].北京:北京航天航空大学出版社,2005.
    [7]沈媛媛,郑恭明,刘益成.基于FPGA的可控震源数字信号发生器设计[J].石油机械,2008(12):27-30.

版权所有:© 2023 中国地质图书馆 中国地质调查局地学文献中心