TiO_2对含钛高炉初渣物相转变与黏度的影响

详细信息    查看全文 | 推荐本文 |

英文篇名：Effect of TiO_2 on phase transition and viscosity of Ti-bearing primary slag in blast furnace 作者：张亚鹏 ; 赵志星 ; 刘征建 ; 潘文 英文作者：ZHANG Ya-peng;ZHAO Zhi-xing;LIU Zheng-jian;PAN Wen;Institute of Ironmaking and Steelmaking Technology,Research Institute of Technology,Shougang Group Corporation;Beijing Key Laboratory of Green Recyclable Process for Iron and Steel Production Technology;School of Metallurgical and Ecological Engineering,University of Science and Technology Beijing; 关键词：TiO_2 ; 高炉初渣 ; 物相转变 ; 黏度 英文关键词：TiO_2;;primary slag of blast furnace;;phase transition;;viscosity 中文刊名：ZGYE 英文刊名：China Metallurgy 机构：首钢集团有限公司技术研究院钢铁技术研究所;绿色可循环钢铁流程北京市重点实验室;北京科技大学冶金与生态工程学院; 出版日期：2019-04-15 出版单位：中国冶金 年：2019 期：v.29 基金：国家重点研发计划专项资助项目(2017YFB0304300,2017YFB0304302) 语种：中文; 页：ZGYE201904002 页数：6 CN：04 ISSN：11-3729/TF 分类号：9-14

摘要

为了研究含钛高炉初渣的形成过程和各种物相成分相互作用、迁移重组的过程,明晰TiO_2对高炉初渣形成的影响规律,利用FactSage热力学软件及旋转柱体式黏度仪研究了TiO_2质量分数对高炉初渣熔化温度、物相转变行为以及初渣黏度的影响。结果表明,随着初渣中TiO_2质量分数的增加,含钛高炉初渣熔化温度升高,TiO_2质量分数从4%增加到16%,其熔化温度从1 360升高到1 410℃,增加了50℃;含钛高炉初渣中TiO_2质量分数对初渣中各种物相组成的转变和比例都有较大的影响,随着TiO_2质量分数的增加,初渣固液相共存的温度区间变大,使高炉软融带变宽;TiO_2对含钛高炉初渣黏度的影响相对较为复杂,当TiO_2质量分数为4%～8%时,含钛高炉初渣黏度-温度曲线呈现出"碱性渣"的形态;当TiO_2质量分数为16%时,含钛高炉初渣黏度-温度曲线呈现出"酸性渣"的形态。
        Effect of TiO_2 on the formation of blast furnace slag was clarified in order to study the formation process of the primary slag containing titanium in blast furnace,the interaction,migration and recombination of various phase components of Ti-bearing primary slag in blast furnace.FactSage thermodynamics software and rotating cylinder viscometer were applied to study the effect of TiO_2 mass fraction on melting temperature,phase transition and viscosity of the primary slag in blast furnace.The results showed that with the increase of TiO_2 mass fraction in primary slag(from 4%to 16%),the melting temperature increased from 1 360 to 1 410℃,increased by 50℃.The mass fraction of TiO_2 in the Ti-bearing primary slag in blast furnace had a great influence on the transformation and proportion of all kinds of phase compositions in the primary slag.The temperature range of the solid-liquid phase coexistence of the primary slag became larger with the increase of TiO_2 mass fraction,which would widen the soft zone of blast furnace.The effect of TiO_2 mass fraction on the primary slag viscosity was complex.When TiO_2 mass fraction was in the range of 4%-8%,the viscosity-temperature curve presented as " alkaline slag".When TiO_2 mass fraction was 16%,the viscosity-temperature curve of the primary slag appeared as "acidic slag".

引文

[1]孙雅平,刘鹏君,吕佳丽,等.高炉配加含钛烧结矿护炉冶炼实践[J].钢铁钒钛,2013,33(5):48.
    [2]许仁泽,张建良,张贺顺,等.TiO2对京唐高炉渣性能的影响及热力学分析[J].钢铁,2017,52(9):104.
    [3]刘东辉,王晓哲,张建良,等.高炉护炉用含钛物料应用现状及调研分析[J].中国冶金,2018,28(2):1.
    [4]司金凤,贾彦忠,李凤臣.配加高镁球团矿高炉炉料结构的研究[J].钢铁研究,2016,43(3):1.
    [5]谢洪恩,秦兴国,郑魁,等.高钛型高炉渣熔化性温度影响因素分析[J].中国冶金,2017,27(9):13.
    [6]陈培敦,孙守建,方爱新,等.软熔带对高炉操作的影响[J].山东冶金,2004,25(3):14.
    [7]张开发,吴胜利,刘新亮,等.MgO含量合理配置对综合炉料熔滴特征及形成初渣特性的影响[J].科学技术与工程,2015,14(15):17.
    [8]张开发,吴胜利,刘新亮,等.不同单种炉料熔滴特征及初渣形成变化[J].科学技术与工程,2015,14(13):36.
    [9]邓朝枢.钒钛烧结矿在高炉内的还原相变[J].钢铁,1985,22(12):46.
    [10]Matsumura M,Hoshi M,Kawaguchi T.Improve of sinter softening property and reducibility by controlling chemical compositions[J].ISIJ International,2005,45(4):594.
    [11]LIU X,WU S,HUANG W,et al.Influence of high temperature interaction between sinter and lump ores on the formation behavior of primary-slags in blast furnace[J].ISIJ International,2014,54(9):2089.
    [12]HUANG W,ZHAO Y,YU S,et al.Effect of CO gas concentration on reduction rate of major mineral phase in sintered iron ore[J].ISIJ International,2016,56(4):594.
    [13]WU S L,HUANG W,KOU M,et al.Influence of Al2O3content on liquid phase proportion and fluidity of primary slag and final slag in blast furnace[J].Steel Research International,2015,86(5):550.
    [14]JIAO K X,ZHANG J,WANG Z,et al.Melting features and viscosity of TiO2-containing primary slag in a blast furnace[J].High Temperature Materials and Processes,2018,37(2):149.
    [15]JIAO K X,ZHANG J,LIU Z,et al.Effect of TiO2and FeO on the viscosity and structure of blast furnace primary slags[J].Steel Research International,2017,88(5):1.
    [16]Kim J R,Lee Y S,Min D J,et al.Influence of MgO and Al2O3contents on viscosity of blast furnace type slags containing FeO[J].ISIJ International,2004,44(8):1291.
    [17]Lee Y S,Kim J R,Jung S M,et al.Influence of basicity and FeO content on viscosity of blast furnace type slags containing FeO[J].ISIJ International,2004,44(8):1283.
    [18]曹战民,宋晓艳,乔芝郁.热力学模拟计算软件FactSage及其应用[J].稀有金属,2008(2):216.
    [19]常治宇,张建良,许仁泽,等.Al2O3对酒钢低铝渣黏度的影响及热力学分析[J].中国冶金,2018,28(8):6.
    [20]AI X,HAO B,ZHAO L,et al.Thermodynamic analysis and formula optimization of steel slag-based ceramic materials by FactSage software[J].International Journal of Minerals Metallurgy and Materials,2013,20(4):379.
    [21]CHENG Z,GUO J,CHENG S.Inclusion composition control during LF refining for SPCC using Factsage combined with industrial trials[J].Journal of Iron and Steel Research,International,2013,20(2):14.
    [22]王志宇,张建良,张邦志,等.高镁铝高炉渣的冶金性能[J].中国冶金,2016,26(4):15.