复杂环境下采场结构参数优化与自适应表征分析
|
摘要
复杂矿体条件下的采矿结构参数是矿山合理安全开采的关键。以卧虎山矿29线附近矿体为研究对象,运用3DMine-Midas-Flac3D耦合建模数值模拟技术,精细化构建三维实体和网格模型,考虑采场跨度和高度,均匀设计15组试验方案,以岩体力学参数的中间值为计算基础参数,获得不同采场跨度和高度下采场的拉压应力、位移和塑性区分布规律,从复杂条件的参数区间自适应优化采场结构参数。研究结果表明:①矿体开挖后,采空区顶底板出现了拉应力集中,特别是在两个采空区之间所留下的间柱之间、回采采场中间的矿柱是塑性区集中区域;②分析各方案中一步骤采场回采完毕后采空区的稳定性状况,确定方案七和方案十二的采场稳定性较好;③对采场不同结构参数下自适应性表征分析,得出方案七的自适应性更强,为最佳采场结构参数,即采场长30m,跨度12. 5m,高度12. 5m,预控顶高度3. 5m。
Stope structure parameters under complex orebody conditions were the key to safe and reasonable mining of the mine. Taking the orebody near the 29 th line of Wohushan Mine as the research object, the numerical simulation technology of coupling modeling with3 DMine-Midas-Flac3 D was used to finely construct the 3 D solid and mesh model. Considering the span and height of the stope, the 15 groups of test schemes were designed uniformly, and the intermediate value of the rock mechanics parameters was as the calculated basic parameters, and the tension and compression stress, displacement and distribution law of plastic zone of the stope with the different span and height and the structure parameters of stope optimized adaptively from the parameter interval under complex conditions were obtained. The study results showed that: ①After the excavation of orebody, the tension stress concentration appeared in the roof and floor of the goaf, especially between spacer pillar left between two goaf, and the pillar in the middle of the stoping stope was the concentration region of plastic zone; ②By analyzing the stability state of goaf after completing stoping of one-step stope in each scheme, it was determined that the stope stability of the 7 th and 12 th scheme was better;③According to the analysis of adaptive characterization of different structural parameters of stope, it was concluded that the adapt ability of the 7 th scheme was stronger, and its stope structure parameters were optimal, and the length was 30 m, the span was 12. 5 m, the height was 12. 5 m, and the height of pre-controlling roof was 3. 5 m.
Stope structure parameters under complex orebody conditions were the key to safe and reasonable mining of the mine. Taking the orebody near the 29 th line of Wohushan Mine as the research object, the numerical simulation technology of coupling modeling with3 DMine-Midas-Flac3 D was used to finely construct the 3 D solid and mesh model. Considering the span and height of the stope, the 15 groups of test schemes were designed uniformly, and the intermediate value of the rock mechanics parameters was as the calculated basic parameters, and the tension and compression stress, displacement and distribution law of plastic zone of the stope with the different span and height and the structure parameters of stope optimized adaptively from the parameter interval under complex conditions were obtained. The study results showed that: ①After the excavation of orebody, the tension stress concentration appeared in the roof and floor of the goaf, especially between spacer pillar left between two goaf, and the pillar in the middle of the stoping stope was the concentration region of plastic zone; ②By analyzing the stability state of goaf after completing stoping of one-step stope in each scheme, it was determined that the stope stability of the 7 th and 12 th scheme was better;③According to the analysis of adaptive characterization of different structural parameters of stope, it was concluded that the adapt ability of the 7 th scheme was stronger, and its stope structure parameters were optimal, and the length was 30 m, the span was 12. 5 m, the height was 12. 5 m, and the height of pre-controlling roof was 3. 5 m.
引文
[1]陈顺满,吴爱祥,王贻明,等.基于响应面法的破碎围岩条件下采场结构参数优化研究[J].岩石力学与工程学报,2017,(增刊1):3499-3508.
[2]徐帅,安龙,李元辉,等.基于SOM的深埋厚大矿体采场结构参数优化研究[J].采矿与安全工程学报,2015,(6):883-888.
[3]胡建华,郭福钟,罗先伟,等.缓倾斜中厚矿体崩落开采矿石流动规律仿真与放矿参数优化[J].中南大学学报:自然科学版,2015,(5):1772-1777.
[4]欧阳鑫,周利华,谷新建,等.点柱上向水平分层充填法采场结构参数优化[J].矿业工程研究,2015,(1):46-51.
[5]李龙福,江东平.胶结充填体下采场结构参数优化研究[J].金属矿山,2014,(12):35-39.
[6]周伟永.阿舍勒铜矿深部矿体采场结构参数优化和稳定性研究[D].赣州:江西理工大学,2013.
[7]张辉.基于数值模拟的大红山铁矿采场结构参数优化[D].昆明:昆明理工大学,2013.
[8]刘洋树,李安平,王刚,等.VCR法采场结构参数优化的相似模型实验[J].有色矿冶,2011,(2):10-15.
[9]刘钦,刘志祥,刘爱华,等.金矿采场结构参数混沌优化[J].采矿与安全工程学报,2010,(4):548-552.
[10]陶干强,刘振东,任凤玉,等.无底柱分段崩落法采场结构参数优化研究[J].煤炭学报,2010,(8):1269-1272.
[11]胡建华,胡昱,周科平,等.裂隙矿段多尺度精细分区模型构建[J].矿冶工程,2015,(2):1-5.
[12]洪武,吴爱祥,杨仕教,等.基于GA-模糊可靠度的采场结构参数优化设计[J].武汉理工大学学报,2010,(9):89-92.
[13]江兵.大冶铁矿无底柱分段崩落法采场结构参数优化的研究[D].武汉:武汉科技大学,2008.
[2]徐帅,安龙,李元辉,等.基于SOM的深埋厚大矿体采场结构参数优化研究[J].采矿与安全工程学报,2015,(6):883-888.
[3]胡建华,郭福钟,罗先伟,等.缓倾斜中厚矿体崩落开采矿石流动规律仿真与放矿参数优化[J].中南大学学报:自然科学版,2015,(5):1772-1777.
[4]欧阳鑫,周利华,谷新建,等.点柱上向水平分层充填法采场结构参数优化[J].矿业工程研究,2015,(1):46-51.
[5]李龙福,江东平.胶结充填体下采场结构参数优化研究[J].金属矿山,2014,(12):35-39.
[6]周伟永.阿舍勒铜矿深部矿体采场结构参数优化和稳定性研究[D].赣州:江西理工大学,2013.
[7]张辉.基于数值模拟的大红山铁矿采场结构参数优化[D].昆明:昆明理工大学,2013.
[8]刘洋树,李安平,王刚,等.VCR法采场结构参数优化的相似模型实验[J].有色矿冶,2011,(2):10-15.
[9]刘钦,刘志祥,刘爱华,等.金矿采场结构参数混沌优化[J].采矿与安全工程学报,2010,(4):548-552.
[10]陶干强,刘振东,任凤玉,等.无底柱分段崩落法采场结构参数优化研究[J].煤炭学报,2010,(8):1269-1272.
[11]胡建华,胡昱,周科平,等.裂隙矿段多尺度精细分区模型构建[J].矿冶工程,2015,(2):1-5.
[12]洪武,吴爱祥,杨仕教,等.基于GA-模糊可靠度的采场结构参数优化设计[J].武汉理工大学学报,2010,(9):89-92.
[13]江兵.大冶铁矿无底柱分段崩落法采场结构参数优化的研究[D].武汉:武汉科技大学,2008.
© 2004-2018 中国地质图书馆版权所有 京ICP备05064691号 京公网安备11010802017129号 地址：北京市海淀区学院路29号 邮编：100083 电话：办公室：(+86 10)66554848；文献借阅、咨询服务、科技查新：66554700 |