Ultra-lightweight cellulose foam material: preparation and properties

详细信息    查看全文

• 作者：Ran Li ; Jinyan Du ; Yanmei Zheng ; Yueqin Wen ; Xinxiang Zhang ; Wenbin Yang&#8230
• 关键词：Cellulose ; Ultra ; lightweight foam ; NaOH/urea aqueous solution ; Porous materials ; Multilevel pore
• 刊名：Cellulose
• 出版年：2017
• 出版时间：March 2017
• 年：2017
• 卷：24
• 期：3
• 页码：1417-1426
• 全文大小：
• 刊物类别：Chemistry and Materials Science
• 刊物主题：Bioorganic Chemistry; Physical Chemistry; Organic Chemistry; Polymer Sciences;
• 出版者：Springer Netherlands
• ISSN：1572-882X
• 卷排序：24

文摘

Ultra-lightweight cellulose foams were prepared by regeneration of sodium dodecyl sulfate (SDS)/cellulose/NaOH/urea blend solution via mechanical agitation and then freeze-drying. The morphology and properties of the blend solutions and foams were investigated via optical microscope, rheometer, BET and SEM. As a result, it was found that the inclusion complex structure between cellulose macromolecules and the solvent molecules was not destroyed. Moreover, the bubbles were about 20–50 μm in the solutions and larger (>100 μm) in the foams. Not only the micropores (bubbles) but also the nanopores could be observed in the wet and dried foams. The cellulose foams possessed ultra-low density of about 30 mg/cm3 and high specific surface area. The result of X-ray diffraction and Fourier transform infrared spectroscopy indicated that the cellulose foams were transited from cellulose I to cellulose II after dissolution and gelation. Bubbles inside the wet foams weakened the mechanical properties, but inversely increased the mechanical properties in the dried foams. Typical “J”-shaped curves were observed during the mechanical test, which revealed good compressive strength of dried foams. In this work, cellulose foams with ultra-lightweight and good mechanical properties were obtained, which exhibited great potentials for further development and comprehensive utilization of cellulose.