Strain-induced martensitic transformation in stainless steels: A three-dimensional phase-field study

详细信息    查看全文

• 作者：Hemantha Kumar Yeddu ; Turab Lookman ; Avadh Saxena
• 关键词：Phase-field modeling ; Strain-induced martensite ; Microstructure evolution ; Stainless steels ; Mechanical properties
• 刊名：Acta Materialia
• 出版年：2013
• 出版时间：October, 2013
• 年：2013
• 卷：61
• 期：18
• 页码：6972-6982
• 全文大小：2070 K

文摘

A three-dimensional elastoplastic phase-field model is developed to study the microstructure evolution during strain-induced martensitic transformation in stainless steels under different stress states. The model also incorporates linear isotropic strain hardening. The input simulation data is acquired from different sources, such as CALPHAD, ab initio calculations and experimental measurements. The results indicate that certain stress states, namely uniaxial tensile, biaxial compressive and shear strain loadings, lead to single variant formation in the entire grain, whereas others, such as uniaxial compressive, biaxial tensile and triaxial strain loadings, lead to multivariant microstructure formation. The effects of stress states, strain rate as well as temperature on the mechanical behavior of steels are also studied. The material exhibits different yield stresses and hardening behavior under different stress states. The equivalent stress is higher at low strain rate, whereas a higher elongation is obtained at high strain rate. The deformation temperature mainly affects the hardening behavior of the material as well as the transformation, i.e. martensite volume fraction decreases with increasing temperature. Some of the typical characteristics of strain-induced martensite, such as the formation of thin elongated martensite laths, shear band formation and nucleation of martensite in highly plasticized areas, as well as at shear band intersections, are also observed.